1.1 本规范规定了无人机系统（UAS）操作员的培训要求和培训手册的编制。 1.2 本规范阐述了为内部培训项目和向公众提供的项目而对专业运营商的文件编制和组织（即薪酬和雇佣）的要求或最佳实践，或两者兼而有之。 1.3 本规范支持将获得CAA操作员认证的专业实体，并为其自身提供实践标准- 或UAS运营商的第三方审计。 1.4 用于制定本规范的标准案例研究侧重于轻型无人机操作员（EASA定义的1320磅/600千克以下），但该规范可适用于使用其他分类方法（即基于风险的等级和飞行员特权等级）的大型飞机。 1.5 不包括本规范所有最低要求的培训手册可能不符合本规范。 1.6 以英寸-磅单位表示的值应视为标准值。 括号中给出的值是对SI单位的数学转换，仅供参考，不被视为标准值。 1.7 本标准并不旨在解决与其使用相关的所有安全问题（如有）。本标准的使用者有责任在使用前建立适当的安全、健康和环境实践，并确定监管限制的适用性。 1.8 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《国际标准、指南和建议制定原则决定》中确立的国际公认标准化原则制定的。

1.1 This specification defines the requirements for training and the development of training manuals for the unmanned aircraft systems (UAS) operator. 1.2 The specification addresses the requirements or best practices, or both, for documentation and organization of a professional operator (that is, for compensation and hire) for the purposes of internal training programs and for programs offered to the general public. 1.3 This specification supports professional entities that will receive operator certification by a CAA, and provide standards of practice for self- or third-party audit of operators of UAS. 1.4 The standard case study used to develop this specification focused on operators of light UAS (below 1320 lb/600 kg as defined by EASA), but the specification may be applied to larger aircraft for using other methods of classification (that is, risk based classes and pilot privileges classes). 1.5 Training manuals that do not include all the minimum requirements of this specification may not be referred to as meeting this specification. 1.6 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.