本文件规定了带或不带滑动工作台和/或可拆卸供电装置且能够连续生产使用的圆锯台的安全要求和措施，也称为“台式锯”（在美国），以下也称为“机器”。 这些机器设计用于切割具有与木材相似物理特性的木材和材料。 当按照预期和制造商预见的条件操作、调整和维护机器时，其处理附录A中列出的与机器相关的所有重大危险、危险情况和事件；也考虑了合理可预见的滥用。运输、组装、拆卸、禁用和报废阶段也已考虑在内。 它也适用于装有以下一个或多个装置或工作装置的机器，其危险已得到处理: -主锯片和划线锯片通过工作台升降的装置； -倾斜主锯片和划线锯片以进行角度切割的装置； -划线装置； -一次通过宽度不超过20 mm的铣刀开槽装置； -可拆卸供电装置； -附加手动滑动台； -电动工件夹紧装置。 本文件不适用于: a） 建筑工地室外使用的机器； 注1:ISO 19085 10:2018的要求涵盖了建筑工地锯（承包商锯）。 b） 手持式木工机械，包括允许其在不同模式下使用的任何改装，即。 e、 ，工作台安装； c） 拟在潜在爆炸性环境中使用的机器； d） 在其作为国际标准出版之日之前制造的机器。

This document specifies the safety requirements and measures for circular saw benches with or without sliding table and/or demountable power feed unit and capable of continuous production use, also known as “table saws” (in the USA), hereinafter referred to also as “machines”. The machines are designed to cut wood and material with similar physical characteristics to wood. It deals with all significant hazards, hazardous situations and events as listed in Annex A relevant to the machines when operated, adjusted and maintained as intended and under the conditions foreseen by the manufacturer; reasonably foreseeable misuse has been considered too. Transport, assembly, dismantling, disabling and scrapping phases have also been taken into account. It is also applicable to machines fitted with one or more of the following devices, or working unit, whose hazards have been dealt with: — device for the main saw blade and scoring saw blade to be raised and lowered through the table; — device to tilt the main saw blade and scoring saw blade for angled cutting; — device for scoring; — device for grooving with milling tool with a width not exceeding 20 mm in one pass; — demountable power feed unit; — additional manually operated sliding table; — powered workpiece clamping device. This document does not apply to: a) machines intended for outdoor use on building sites; NOTE 1 Building site saws (contractor saws) are covered by the requirements of ISO 19085 10:2018. b) handheld woodworking machines including any adaptation permitting their use in a different mode, i.e., bench mounting; c) machines intended for use in a potentially explosive atmosphere; d) machines manufactured prior to the date of its publication as an International Standard.