本欧洲标准规定了计算机放射学的基本技术，目的是令人满意 经济上可以获得可重复的结果。这些技术是基于这个主题的基本理论 测试测量。本文件规定了工业计算机X射线和γ射线照相术的一般规则 检测目的，使用存储荧光成像板（IP）。它是基于射线照相的一般原理 在电影基础上检查金属材料（ISO 5579）。辐射源，检测器的基本设置 应符合ISO 5579和相应产品标准的相应几何应用。 ISO 焊接用17636，铸造用EN 12681。它不排除瑕疵的验收标准。数字 检测器提供数字灰度值图像，可以仅基于计算机查看和评估。这种做法 描述了检测器选择和放射照相术实践的推荐步4568骤。选择电脑，软件， 显示器，打印机和查看条件很重要，但不在本标准的主要焦点。 本标准规定的程序提供了允许暴露的最低要求和实践 获得

ISO 16371-2:2017 specifies fundamental techniques of computed radiography with the aim of enabling satisfactory and repeatable results to be obtained economically. The techniques are based on the fundamental theory of the subject and tests measurements. ISO 16371-2:2017 specifies the general rules for industrial computed X-rays and gamma radiography for flaw detection purposes, using storage phosphor imaging plates (IP). It is based on the general principles for radiographic examination of metallic materials on the basis of films, as specified in ISO 5579. The basic set-up of radiation source, detector and the corresponding geometry are intended to be applied in accordance with ISO 5579 and corresponding product standards such as ISO 17636 for welding and EN 12681 for foundry. ISO 16371-2:2017 does not lay down acceptance criteria of the imperfections. Computed radiography (CR) systems provide a digital grey value image which can be viewed and evaluated on basis of a computer only. This practice describes the recommended procedure for detector selection and radiographic practice. Selection of computer, software, monitor, printer and viewing conditions are important but not the main focus of ISO 16371-2:2017. The procedure it specifies provides the minimum requirements and practice to permit the exposure and acquisition of digital radiographs with a sensitivity of imperfection detection equivalent to film radiography and as specified in ISO 5579. Some application standards, e.g. EN 16407, can require different and less stringent practice conditions.