首页 馆藏资源 舆情信息 标准服务 科研活动 关于我们
现行 ASTM B115-24
到馆提醒
收藏跟踪
购买正版
Standard Specification for Electrolytic Copper Cathode 电解铜阴极标准规范
发布日期: 2024-10-01
1.1 本规范涵盖了电解铜阴极的要求;电解精炼和电解。 1.2 单位- 以英寸-磅单位表示的值应被视为标准值。括号中给出的值是对SI单位的数学转换,仅供参考,不被视为标准。 附注1: 根据本说明书生产的阴极对应于分类中定义的名称“Cath” B224 并可用于生产分类中列出的所有其他铜 B224 通常由“导管”铜制成。 附注2: 1级阴极符合铜UNS No.C11040的化学成分要求,氧除外,适用于生产规范中指定的线材 B49 . 1.3 以下危险警告适用于中描述的试验方法 附件A2 本规范: 本标准并不旨在解决与其使用相关的所有安全性问题(如果有)。本标准的使用者有责任在使用前建立适当的安全、健康和环境实践并确定法规限制的适用性。 1.4 本国际标准是根据世界贸易组织技术性贸易壁垒(TBT)委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。 ======意义和用途====== 13.1 计算值应按照实践中的指示四舍五入到所需的位数 E29 .
1.1 This specification covers the requirements for electrolytic copper cathode; electrorefined and electrowon. 1.2 Units— The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. Note 1: Cathode produced to this specification corresponds to the designation “Cath” as defined in Classification B224 and may be used to produce all other coppers listed in Classification B224 that are normally produced from “Cath” copper. Note 2: Grade 1 cathode conforms to the chemical compositional requirements of Copper UNS No. C11040, except for oxygen, and is suitable for the manufacture of wire rod as designated in Specification B49 . 1.3 The following hazard caveat applies to the test methods described in Annex A2 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 13.1 Calculated values shall be rounded to the desired number of places as directed in Practice E29 .
分类信息
关联关系
研制信息
归口单位: B05.07
相似标准/计划/法规
现行
KS D 2341(2019 Confirm)
전기 동 지금
电解阴极铜
2014-12-31
现行
JIS H 2121-1961
Electrolytic cathode copper
电解阴极铜
1961-01-01
现行
JIS H 1101-1990
Methods for chemical analysis of electrolytic cathode copper
电解阴极铜化学分析方法
1990-01-01
现行
KS D 1890(2020 Confirm)
전기 동 분석 방법
电解阴极铜的化学分析方法
2012-05-08
现行
KS D 1899
전기동의 방출 분광 분석 방법
电解阴极铜光电发射光谱化学分析方法
2019-05-02
现行
GOST 546-2001
Катоды медные. Технические условия
铜阴极 规格
2001-05-24
现行
ASTM B170-24
Standard Specification for Oxygen-Free Electrolytic Copper—Refinery Shapes
无氧电解铜精炼型材标准规范
2024-07-01
现行
MIL MIL-C-83500 Amendment 3
CAPACITORS, FIXED, ELECTROLYTIC (NONSOLID ELECTROLYTE), TANTALUM CATHODE, GENERAL SPECIFICATION FOR (S/S BY MIL-PRF-83500A)
钽阴极固定电解电容器(非固体电解质)通用规范
1994-02-23
现行
MIL MIL-C-83500 Notice 1-Validation
CAPACITORS, FIXED, ELECTROLYTIC (NONSOLID ELECTROLYTE), TANTALUM CATHODE, GENERAL SPECIFICATION FOR (S/S BY MIL-PRF-83500A)
电容器 固定电解质(非溶剂电解质) TANTALUM CATHODE 通用规格(S/S MIL-PRF-83500A)
1987-02-27
现行
MIL MIL-C-83500 Amendment 2
CAPACITORS, FIXED, ELECTROLYTIC (NONSOLID ELECTROLYTE), TANTALUM CATHODE, GENERAL SPECIFICATION FOR (S/S BY MIL-PRF-83500A)
电容器 固定电解质(非溶剂电解质) TANTALUM CATHODE 通用规格(S/S MIL-PRF-83500A)
1980-06-16
现行
MIL MIL-PRF-83500A
CAPACITORS, FIXED, ELECTROLYTIC (NONSOLID ELECTROLYTE), TANTALUM ANODE AND CATHODE, GENERAL SPECIFICATION FOR (SUPERSEDING MIL-C-83500)
钽阳极和阴极电解(非固体电解质)固定电容器通用规范(代替MIL-C-83500)
2002-10-01
现行
MIL MIL-C-83500
CAPACITORS, FIXED, ELECTROLYTIC (NONSOLID ELECTROLYTE), TANTALUM CATHODE, GENERAL SPECIFICATION FOR (S/S BY MIL-PRF-83500A)
钽阴极电解(非固体电解质)固定电容器通用规范(MIL-PRF-83500A S/S)
1975-06-19
现行
ECA/EIA 955
Surface Mount Aluminum Electrolytic Chip Capacitor with Polymer Cathode (Qualification Specification)
聚合物阴极表面安装铝电解片式电容器(鉴定规范)
2007-10-01
现行
ASTM D3482-07a(2023)
Standard Practice for Determining Electrolytic Corrosion of Copper by Adhesives
用粘合剂测定铜的电解腐蚀的标准实施规程
2023-01-01
现行
QPL QPL-83500-8
CAPACITORS, FIXED, ELECTROLYTIC (NONSOLID ELECTROLYTE), TANTALUM ANODE AND CATHODE, GENERAL SPECIFICATION FOR (SUPERSEDING QPL-83500-7) (NO S/S DOCUMENT)
钽阳极和阴极电解(非固体电解质)固定电容器通用规范(代替QPL-83500-7)(无S/S文件)
2004-02-13
现行
QPL QPL-83500-8
CAPACITORS, FIXED, ELECTROLYTIC (NONSOLID ELECTROLYTE), TANTALUM ANODE AND CATHODE, GENERAL SPECIFICATION FOR (SUPERSEDING QPL-83500-7) (NO S/S DOCUMENT)
钽阳极和阴极电解(非固体电解质)固定电容器通用规范(代替QPL-83500-7)(无S/S文件)
2004-02-13
现行
ASTM A601/A601M-10(2020)
Standard Specification for Electrolytic Manganese Metal
电解金属锰的标准规范
2020-03-01
现行
ASTM B843-18e1
Standard Specification for Magnesium Alloy Anodes for Cathodic Protection
ASTM A845/A866M-00(2005)阴极保护用镁合金阳极的标准规范
2018-05-01
现行
ASTM A1093/A1093M-15(2020)e1
Standard Specification for Electrolytic Plasma Treatment Processing of Conductive Materials
导电材料电解等离子体处理加工标准规范
2020-01-01
现行
ASTM B432-19
Standard Specification for Copper and Copper Alloy Clad Steel Plate
铜和铜合金复合钢板的标准规范
2019-04-01