1.1 本规范涵盖通过双辊铸造工艺生产的冷轧、碳素、结构和高强度低合金卷和切割长度。 1.2 通过双辊铸造工艺生产的冷轧钢板的名称如下 4.1 。 1.3 本规范不适用于规范中所述的钢带 109/109米 。 1.4 以国际单位制或英寸磅单位表示的数值应单独视为标准。每个系统中规定的值可能不是完全相等的； 因此，每个系统应独立使用。将两个系统的值合并可能导致不符合标准。 1.5 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的使用者有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.6 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。

1.1 This specification covers cold-rolled, carbon, structural, and high-strength low-alloy, in coils and cut lengths produced by the twin-roll casting process. 1.2 Cold rolled steel sheet produced by the twin-roll casting process is available in the designations as listed in 4.1 . 1.3 This specification does not apply to steel strip as described in Specification A109/A109M . 1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.