本文件规定了一种测试方法，用于评估涂料和清漆（包括木材污渍）在直角格子图案为 切开涂层，穿透基底。该经验试验程序确定的性能取决于涂层与 前涂层或基体。然而，该程序不是测量附着力的方法。 注1:如果需要测量附着力，请参阅ISO 4624中所述的方法。 注意 2尽管试验主要用于实验室，但试验也适用于现场试验。 所述方法可用于通过/失败测试，或 适合于六步分类测试。当应用于多涂层系统时，评估涂层各层之间的抗分离性可以 制造的。 可在成品和/或特殊制备的试样上进行试验。 尽管该方法适用于硬（如金属）和软（如木材和灰泥）上的油漆 基板，这些不同的基板需要不同的测试程序（见第8条）。 该方法不适用于总厚度大于250µm的涂层或纹理涂层。 注3:当该方法应用于设计成粗糙图案表面的涂层时，其结果将显示出太多的变化（另见ISO 16276-2）。

This document specifies a test method for assessing the resistance of paint coatings and varnishes (including wood stains) to separation from substrates when a right-angle lattice pattern is cut into the coating, penetrating through to the substrate. The property determined by this empirical test procedure depends, among other factors, on the adhesion of the coating to either the preceding coat or the substrate. This procedure is not, however, a means of measuring adhesion. NOTE 1 Where a measurement of adhesion is required, see the method described in ISO 4624. NOTE 2 Although the test is primarily intended for use in the laboratory, the test is also suitable for field testing. The method described can be used either as a pass/fail test or, where circumstances are appropriate, as a six-step classification test. When applied to a multi-coat system, assessment of the resistance to separation of individual layers of the coating from each other can be made. The test can be carried out on finished objects and/or on specially prepared test specimens. Although the method is applicable to paint on hard (e.g. metal) and soft (e.g. wood and plaster) substrates, these different substrates need a different test procedure (see Clause 8). The method is not suitable for coatings of total thickness greater than 250 µm or for textured coatings. NOTE 3 The method, when applied to coatings designed to give a rough patterned surface, will give results which will show too much variation (see also ISO 16276-2).