AMS5880E取消了之前的取消和替代，同时tim确定了该文件，因为它仍在轴承行业中使用。作为历史参考，AMS5880的修订版D取消了该文件，并用AMD 5618AMS5880E取代该文件，该文件已被宣布为“稳定”，不再接受货币定期审查。用户负责验证参考文件和技术要求的持续适用性。新技术可能存在。本文件的最后一次技术更新发生在2006年5月。本文件的使用者应将任何认证问题（如认证报告中列出的例外情况）提交给承包商工程组织处理。 警告:在许多情况下，买方不是联合工程组织（即买方可能是次级供应商）。>p> AMS F委员会建议在未来的生产中使用以下同等技术规范（如属性、配合、形式、功能）。本清单不构成用这些规范代替“稳定”规范的权力。AMS5618和AMS5630。t本规范涵盖棒材、线材、锻件和锻坯形式的耐腐蚀钢。这些产品通常用于要求耐腐蚀和磨损的耐磨轴承零件，淬火和回火后硬度通常不低于58 HRC，但使用不限于此类应用。

AMS5880E rescinds the previous cancellation and supersession, and at the same tim estabilizes the document becasue it still has use in the bearing industry. For historical reference, revision D of AMS5880 cancelled the document and superseded it with AMD 5618AMS5880E has been declared "STABILIZED" and will no longer be subjected to periodic reviews for currency. Users are responsible for verifying references and continued suitability of technical requirements. New technology may exist. The last technical update of this document occured in May, 2006. Users of this document should refer any certification issues (e.g. exceptions listed on the certification report) to the congnizant engineering organization for their disposition. CAUTION: In many cases the purchaser is not the congnizant engineering organizaiton (i.e. purchaser may be a sub tier supplier.)>p>AMS Committee F recommends that the following technically equivalent (e.g. properties, fit, form, funciton) specification be used for future prodcurement. This listing does not constitute authority to substitute these specifications for the "STABILIZED" specification. AMS5618 and AMS5630.TThis specification covers a corrosion-resistant steel in the form of bars, wire, forgings, and forging stock.These products have been used typically for anti-friction bearing parts requiring resistance to both corrosion and wear with hardness usually not lower than 58 HRC after hardening and tempering, but usage is not limited to such applications.