1.1 本规范涵盖了一组通用要求，除非采购订单或单个规范中另有规定，否则这些要求应适用于锡轧机产品。 1.2 如果要求有冲突，应按指定顺序以采购订单、单个材料规范和本通用规范的要求为准。 注1: 规格的完整英寸磅配对 A623M 已制定规范 A623型 ; 因此，未提供英寸-磅当量。 1.3 以下安全隐患警示盖 附件A1 通过 附录A8 本规范: 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.4 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。

1.1 This specification covers a group of common requirements, which unless otherwise specified in the purchase order or in an individual specification, shall apply to tin mill products. 1.2 In case of conflict in requirements, the requirements of the purchase order, the individual material specification, and this general specification shall prevail in the sequence named. Note 1: A complete inch-pound companion to Specification A623M has been developed—Specification A623 ; therefore, no inch-pound equivalents are presented. 1.3 The following safety hazards caveat covers Annex A1 through Annex A8 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.