IEC 62351-100-3:20 20是一项技术规范，描述了远动设备、变电站自动化系统[SAS]和远动系统的数据和通信安全测试用例，包括SCADA的前端功能。 本文档的目标是通过提供测试协议实现的标准方法来验证设备是否满足IEC 62351-3的要求，从而实现互操作性。请注意，符合IEC 62351-3并不能保证使用不同实现的设备之间的互操作性。预计在测试期间使用该规范将最大限度地降低非互操作性的风险。这种互操作性的基本条件是两个设备都通过了一致性测试。 本文件的范围是一致性和/或互操作性测试的通用可用程序和定义的规范，以确保符合IEC 62351-3.这里定义的一致性测试用例集中于验证底层认证/加密协议(TLS)的一致性集成，如IEC 62351-3中所规定的，以保护基于TCP/IP的通信。 本文档无意测试IEC 62351-3要求在TCP/IP（TLS）上实现的底层身份验证/加密协议。TCP/IP上的身份验证/加密协议的一致性测试超出了本文档的范围。 本文档涉及数据和通信安全一致性测试；因此，不包括其他要求，如安全性或EMC。这些要求由其他标准（如果适用）涵盖，这些主题的合规性证明是根据这些标准完成的。

IEC 62351-100-3:2020, which is a technical specification, describes test cases of data and communication security for telecontrol equipment, Substation Automation Systems [SAS] and telecontrol systems, including front-end functions of SCADA.
The goal of this document is to enable interoperability by providing a standard method of testing protocol implementations to verify that a device fulfils the requirement of IEC 62351-3. Note that conformity to IEC 62351-3 does not guarantee interoperability between devices using different implementations. It is expected that using this specification during testing will minimize the risk of non-interoperability. A basic condition for this interoperability is a passed conformance test of both devices.
The scope of this document is the specification of common available procedures and definitions for conformance and/or interoperability testing to ensure conformity to IEC 62351-3. The conformance test cases defined here are focused to verify the conformant integration of the underlying authentication/encryption protocol (TLS), as specified in IEC 62351-3, to protect TCP/IP based communications.
This document is not intended to test the underlying authentication/encryption protocol required by IEC 62351-3 to be implemented over TCP/IP (TLS). The conformance testing of the authentication/encryption protocol over TCP/IP is outside the scope of this document.
This document deals with data and communication security conformance testing; therefore, other requirements, such as safety or EMC are not covered. These requirements are covered by other standards (if applicable) and the proof of compliance for these topics is done according to these standards.