1.1 本规范涵盖通过连续热浸工艺涂覆保护锌或锌合金涂层的钢筋。 注1: 镀锌机在本规范中被确定为制造商。 1.2 施工现场施工实践指南见 附录X1 . 1.3 带非镀锌钢模板的连续热浸镀锌钢筋的使用指南见 附录X2 . 1.4 本规范的正文引用了提供解释材料的注释和脚注。这些注释和脚注不应视为本规范的要求。 1. 5. 本规范适用于以英寸-磅为单位的订单（作为规范 A1094号 )或国际单位制（作为规范 A1094M ). 1.6 以英寸-磅单位或国际单位表示的数值应单独视为标准值。在文本中，国际单位显示在括号中。每个系统中规定的值可能不是精确的等效值；因此，每个系统应相互独立使用。合并两个系统的值可能会导致不符合本规范。 1.7 本规范无意解决与其使用相关的所有安全问题（如有）。本规范的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.8 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。

1.1 This specification covers steel reinforcing bars, with protective zinc or zinc-alloy coatings applied by the continuous hot-dip process. Note 1: The galvanizer is identified throughout this specification as the manufacturer. 1.2 Guidelines for construction practices at the job-site are presented in Appendix X1 . 1.3 Guidelines for use of continuous hot-dip galvanized reinforcing bars with non-galvanized steel forms are presented in Appendix X2 . 1.4 The text of this specification references notes and footnotes which provide explanatory material. These notes and footnotes shall not be considered requirements of the specification. 1.5 This specification is applicable for orders in either inch-pound units (as Specification A1094 ) or SI units (as Specification A1094M ). 1.6 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with this specification. 1.7 This specification does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this specification to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.