范围:本文件描述了一种强制、非共振方法，用于测定频率通常在0.01 Hz至100 Hz范围内的聚合物剪切复合模量G*的成分。可以进行更高频率的测量，但测量的动态特性可能会产生重大误差（见10.2.2和10.2.3）。该方法适用于测量0.1MPa至50MPa范围内的动态存储模量。 注:尽管可以研究模量大于50 MPa的材料，但可以使用扭转变形模式对其动态剪切性能进行更精确的测量（见ISO 6721）- 2和ISO 6721-7）。 该方法特别适用于测量大于0.02的损耗系数，因此可以方便地用于研究大多数玻璃橡胶松弛区的动态特性随温度和频率的变化（见ISO 6721-1）。在频率和温度的大范围内确定的数据的可用性使得可以使用频率/温度偏移程序来导出主图，该程序在不同温度下显示扩展频率范围内的动态特性。 交叉引用:ISO 6721-1ISO 6721-2ISO 6721-7购买本文件时可获得的所有现行修订均包含在购买本文件中。

Scope: This document describes a forced, non-resonance method for determining the components of the shear complex modulusG* of polymers at frequencies typically in the range 0,01 Hz to 100 Hz. Higher-frequency measurements can be made, but significant errors in the dynamic properties measured are likely to result (see 10.2.2 and 10.2.3). The method is suitable for measuring dynamic storage moduli in the range 0,1 MPa to 50 MPa. NOTE Although materials with moduli greater than 50 MPa can be studied, more accurate measurements of their dynamic shear properties can be made using a torsional mode of deformation (see ISO 6721-2 and ISO 6721-7). This method is particularly suited to the measurement of loss factors greater than 0,02 and can therefore be conveniently used to study the variation of dynamic properties with temperature and frequency through most of the glass-rubber relaxation region (see ISO 6721-1). The availability of data determined over wide ranges of both frequency and temperature enables master plots to be derived, using frequency/temperature shift procedures, which display dynamic properties over an extended frequency range at different temperatures.Cross References:ISO 6721-1ISO 6721-2ISO 6721-7All current amendments available at time of purchase are included with the purchase of this document.