前言:这是设备开关的协调CSA组和UL标准-第2-1部分:跳线开关的特殊要求。它是CSA C22.2第61058-2-1号的第一版，也是UL 61058-2-1的第一版。本协调标准基于IEC出版物61058-2-1:第三版，电器开关-第2-1部分:软线开关的特殊要求，2018年6月发布。IEC 61058-2-1受IEC版权所有。本协调标准由CSA集团和美国保险商实验室有限公司（UL）编制。感谢国际家电开关协调委员会的努力和支持。本标准被认为适用于本标准规定范围内的合格评定。本标准由CSA布线设备综合委员会审查，由CSA布线产品技术委员会和CSA电气安全要求战略指导委员会管辖，并已由CSA技术委员会正式批准。 本标准是根据加拿大标准委员会对加拿大国家标准的要求制定的。CSA集团已将其发布为加拿大国家标准。范围IEC 61058-1:2016第1条适用，以下情况除外:补充:本文件适用于手动、脚踏或其他人类活动驱动的电器的软线开关（机械或电子），操作或控制额定电压不超过250 V、额定电流不超过16 a的家用或类似用途的电器和其他设备。在本文件中，“电器”一词是指“电器或设备”。这些开关拟由人员通过执行构件或通过启动传感单元进行操作。执行元件或传感单元可以是整体的，也可以与开关分开布置。 执行元件或传感单元与开关之间的信号传输可以通过物理或电气方式进行（例如，电气、光学、声学或热）。包含由开关功能控制的附加控制功能的开关在本文件范围内。本文件还涵盖了当执行元件或传感单元的操作由遥控器或设备的一部分（如门）提供时，开关的间接驱动。注1:电子开关可与机械开关结合，实现完全断开或微断开。注2:供电电路中没有机械开关的电子开关仅提供电子断开。因此，负载侧的电路始终被视为带电。注3:对于热带气候下使用的开关，可适用其他要求。 注4:值得注意的是，电器标准可能包含开关的附加或替代要求。1DV D2修改:在第2部分第1条中添加以下内容:CSA C22.2第61058号/UL 61058的本部分不适用于软线调光器开关。

PrefaceThis is the harmonized CSA Group and UL standard for Switches for Appliances - Part 2-1: Particular Requirements for Cord Switches. It is the first edition of CSA C22.2 No. 61058-2-1, and the first edition of UL 61058-2-1. This harmonized standard is based on IEC Publication 61058-2-1: third edition, Switches for Appliances - Part 2-1: Particular Requirements for Cord Switches, issued June 2018. IEC 61058-2-1 is copyrighted by the IEC. This harmonized standard was prepared by CSA Group and Underwriters Laboratories Inc. (UL). The efforts and support of the International Harmonization Committee on Switches for Appliances are gratefully acknowledged. This standard is considered suitable for use for conformity assessment within the stated scope of the standard. This standard was reviewed by the CSA Integrated Committee on Wiring Devices, under the jurisdiction of the CSA Technical Committee on Wiring Products and the CSA Strategic Steering Committee on Requirements for Electrical Safety, and has been formally approved by the CSA Technical Committee. This standard has been developed in compliance with Standards Council of Canada requirements for National Standards of Canada. It has been published as a National Standard of Canada by CSA Group.ScopeClause 1 of IEC 61058-1:2016 is applicable except as follows: Addition: This document applies to cord switches (mechanical or electronic) for appliances actuated by hand, by foot or by other human activity, to operate or control electrical appliances and other equipment for household or similar purposes with a rated voltage not exceeding 250 V and a rated current not exceeding 16 A.Throughout this document, the word "appliance" means "appliance or equipment". These switches are intended to be operated by a person, via an actuating member or by actuating a sensing unit. The actuating member or sensing unit can be integral or arranged separately from the switch. The transmission of a signal between the actuating member or sensing unit and the switch can be made either physically or electrically (for example, electrical, optical, acoustic or thermal). Switches which incorporate additional control functions governed by the switch function are within the scope of this document. This document also covers the indirect actuation of the switch when the operation of the actuating member or sensing unit is provided by a remote control or a part of an appliance such as a door.NOTE 1 Electronic switches can be combined with mechanical switches giving full disconnection or micro-disconnection.NOTE 2 Electronic switches without a mechanical switch in the supply circuit provide only electronic disconnection. Therefore, the circuit on the load side is always considered to be live.NOTE 3 For switches used in tropical climates, additional requirements can apply.NOTE 4 Attention is drawn to the fact that the standards for appliances can contain additional or alternative requirements for switches. 1DV D2 Modification: Add the following to Clause 1 of the Part 2: This part of CSA C22.2 No. 61058/UL 61058 does not apply to cord dimmer switches.