1.1 本规范涵盖了根据规范涂有保护性环氧涂层的变形钢筋和普通钢筋的制造和现场要求 A775/A775M . 1.2 本规范适用于国际单位制（规范D3963M）或英寸-磅单位（规范D3963）的订单。 1.3 以国际单位制或英寸-磅单位表示的数值应单独视为标准值。在文本中，英寸-磅单位显示在括号中。每个系统中规定的值不是精确的等价物；因此，每个系统必须相互独立使用。合并两个系统的值可能会导致不符合规范。 1.4 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。

1.1 This specification covers the fabrication and jobsite requirements for deformed and plain steel reinforcing bars with protective epoxy coating applied in accordance with Specification A775/A775M . 1.2 This specification is applicable for orders in either SI units (as Specification D3963M) or inch-pound units (as Specification D3963). 1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.