1.1 本试验方法包括评估工厂在钢上涂覆的薄膜有机涂层的成形性和附着力，涂层厚度为2.5至10微米（0.10至0.40密耳），这是线圈涂层行业典型的涂层厚度。 1.2 成型前的除油程度、胶带技术以及胶带粘合强度的差异都会影响粘合等级。 1.3 以国际单位制表示的数值应视为标准。括号中给出的值仅供参考。 1.4 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 有关具体的危险说明，请参阅第节 7. . 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。 ====意义和用途====== 5.1 变形和胶带联合试验的结果与涂层金属在工厂应用中承受冲压的能力有关。 5.2 该测试可用于确定或控制制造过程，或用于改进产品的涂料开发工作。 5.3 应认识到，由于试验条件和成型机的变化，结果的可变性仍然存在。

1.1 This test method covers the evaluation of the formability and adhesion of factory applied thin film organic coatings on steel having coating thicknesses of 2.5 to 10 microns (0.10 to 0.40 mils) typical of those used in the coil coating industry. 1.2 The degree of oil removal prior to forming, the techniques of taping, and differences in adhesive strength of the tape can affect the adhesion rating. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see Section 7 . 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 5.1 The results of the combined deformation and tape test are related to the ability of the coated metal to withstand stamping in factory applications. 5.2 This test can be used to determine or control the manufacturing process or for coatings development work to improve the product. 5.3 It should be recognized that variability in the results persists due to the test conditions and forming machine variations.