1.1 本规范涵盖了采用静电喷涂法涂覆保护性环氧涂层，然后使用纹理表面处理材料的变形钢筋。 注1: 涂层涂布机在本规范中被标识为制造商。 1.2 可以使用其他有机涂层和纹理表面处理材料，只要它们符合本规范的要求。 1.3 涂层要求见规范附件A1 775米/775米 . 1.4 纹理表面处理材料的要求包含在 附件A1 . 1.5 修补材料要求见规范附件A2 775米/775米 . 1.6 施工现场施工实践指南见 附录X1 . 1.7 本规范适用于任何英寸的订单- 磅单位（如规范A1124）或国际单位制（SI）[如规范A1124M]。 1.8 以英寸-磅单位或国际单位表示的值应单独视为标准值。每个系统中所述的值可能不是完全等效的；因此，每个系统都应独立使用。将两个系统的值结合起来可能会导致不符合标准。 1.9 本标准并不旨在解决与其使用相关的所有安全问题（如果有的话）。本标准的使用者有责任在使用前建立适当的安全、健康和环境实践，并确定监管限制的适用性。 1.10 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。

1.1 This specification covers deformed steel reinforcing bars with protective epoxy coating applied by the electrostatic spray method followed by a texturing surface treatment material. Note 1: The coating applicator is identified throughout this specification as the manufacturer. 1.2 Other organic coatings and texturing surface treatment materials may be used provided they meet the requirements of this specification. 1.3 Requirements for coatings are contained in Annex A1 of Specification A775/A775M . 1.4 Requirements for texturing surface treatment material are contained in Annex A1 . 1.5 Requirements for patching material are contained in Annex A2 of Specification A775/A775M . 1.6 Guidelines for construction practices at the job-site are presented in Appendix X1 . 1.7 This specification is applicable for orders in either inch-pound units (as Specification A1124) or SI units [as Specification A1124M]. 1.8 The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.9 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.10 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.