1.1 本试验方法涵盖一个程序，用于确定压敏胶带与标准纸板或其他类似表面的粘附性。 1.2 该测试方法提供属性响应（通过或失败），不会产生变量或连续尺度上的数值数据。 1.3 以国际单位制或英寸-磅单位表示的数值应单独视为标准值。每个系统中规定的值可能不是精确的等效值；因此，每个系统必须独立使用，不得以任何方式组合值。 1.4 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。 ====意义和用途====== 5.1 胶带在测试温度下的良好性能意味着在测试温度或高于测试温度时的良好低温性能。 5.2 本程序适用于遵守100的问题 % 牛皮纤维板类似于标准衬板表面，无需替换，但对于任何板或表面上的直接信息，应替换有问题的实际表面。

1.1 This test method covers one procedure for determining the adherence of pressure-sensitive tapes to a standard linerboard or other similar surface. 1.2 This test method provides for an attribute response (pass or fail) and does not yield numerical data on a variable or continuous scale. 1.3 The values stated in either SI or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently without combining values in any way. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 5.1 Satisfactory tape performance at the test temperature implies satisfactory cold-temperature performance at or above the test temperature. 5.2 This procedure would be applicable for questions of adherence to 100 % kraft fiberboards similar to the standard linerboard surface without substitution but for direct information on any board or surface, the actual surface in question should be substituted.