ISO 10350确定了获取和呈现塑料某些基本性能可比数据的具体试验程序。一般来说，每个特性由一个单独的实验值指定，尽管在某些情况下，特性由在不同试验条件下或沿材料不同方向获得的两个值表示。所包含的特性是制造商数据表中常规显示的特性。 本文件适用于增强热塑性材料和热固性材料，其中增强纤维在加工前长度大于7.5 mm或连续（e。 g、 织物、连续股毡或单向纤维）。 ISO 10350-1专门针对未增强和填充塑料，包括使用长度小于7.5mm的纤维的塑料。

ISO 10350 identifies specific test procedures for the acquisition and presentation of comparable data for certain basic properties of plastics. In general, each property is specified by a single experimental value, although in certain cases properties are represented by two values obtained under different test conditions or along different directions in the material. The properties included are those presented conventionally in manufacturers' data sheets. This document applies to reinforced thermoplastic and thermosetting materials where the reinforcement fibres are either discontinuous with a fibre length prior to processing greater than 7,5 mm or continuous (e.g. fabric, continuous-strand mat or unidirectional). ISO 10350-1 deals specifically with unreinforced and filled plastics, including those using fibres less than 7,5 mm in length.