本文件规定了第4条所列的所有重要危险，危险情况和事件，这些情况与具有固定工作台和进料辊或进料链的单面成型机（以下简称“机器”）相关，装载和卸载是手动的，最大工件高度为200 mm。该机器设计用于在实木，芯片板，纤维板或胶合板以及这些材料的一侧通过塑料层压板覆盖。工件通过由辊子或链条组成的一体化进料通过处理单元进给。 本文件不适用于可运输机器。 本文档不涉及与以下相关的任何危害: a）工件的机械装载和/或卸载;要么 b）与任何其他机器（作为线路的一部分）组合使用的机器;要么 c）使用激光。 对于计算机数控（CNC）机器，本文档不涉及与电磁兼容性（EMC）相关的危险。 注1:本文档的要求适用于所有机器，无论其控制方法如何。机电和/或电子。 本文件主要针对在CEN发布之日后制造的机器。 注2 Singl

This document specifies all significant hazards, hazardous situations and events as listed in Clause 4 which are relevant to one side profiling machines with fixed table and feed rollers or feed chain hereinafter referred to as "machines", where the loading and unloading is manual and where the maximum work-piece height capacity is 200 mm. The machine is designed to process in one pass one side of solid wood, chip board, fibreboard or plywood and also these materials where they are covered with plastic laminate. The work-piece is fed through the processing units by an integrated feed consisting of rollers or a chain. This document does not apply to transportable machines. This document does not deal with any hazards relating to: a) mechanical loading and/ or unloading of the work-piece; or b) a machine being used in combination with any other machine (as part of a line); or c) use of laser. For Computer Numerically Controlled (CNC) machines this document does not cover hazards related to Electro-Magnetic Compatibility (EMC). NOTE 1 The requirements of this document apply to all machines whatever their method of control e.g. electromechanical and/or electronic. This document is primarily directed to machines which are manufactured after the date of publication by CEN. NOTE 2 Single end tenoning machines with sliding table are dealt with in EN 1218-1:1999. Double end tenoning and/or profiling machines fed by chain or chains are dealt with in EN 1218-2. Single end tenoning machines where the tenon is produced only by means of saw-blades are dealt with in EN 1218-3.