1.1 本规范 2. 镍钼合金盖板、薄板和带材（UNS N10001、N10665、N10675、N10629和N10624） 3. 如所示 表1 ，用于一般腐蚀性环境。 1.2 本规范涵盖以下产品: 1.2.1 板材和带材- 热轧或冷轧、固溶退火和除垢，除非在产生光亮表面的气氛中进行固溶退火。 1.2.2 钢板- 热轧或冷轧、固溶退火和除垢。 1.3 以英寸-磅为单位的数值应视为标准值。 括号中给出的值是到国际单位制的数学转换，仅供参考，不被视为标准值。 1.4 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任熟悉所有危险，包括制造商提供的本产品/材料的适当安全数据表（SDS）中确定的危险，建立适当的安全、健康和环境实践，并在使用前确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。

1.1 This specification 2 covers plate, sheet, and strip of nickel-molybdenum alloys (UNS N10001, N10665, N10675, N10629, and N10624) 3 as shown in Table 1 , for use in general corrosive service. 1.2 The following products are covered under this specification: 1.2.1 Sheet and Strip— Hot or cold rolled, solution annealed, and descaled unless solution anneal is performed in an atmosphere yielding a bright finish. 1.2.2 Plate— Hot or cold rolled, solution annealed, and descaled. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety, health, and environmental practices, and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.