1.1本规范涵盖了新的线装通用（GP）配电板（以下简称线装箱）装运箱的制造，用于国内和海外运输一般材料和物资的集装箱，1级国内运输不超过500 lb[226.8 kg]，对于第2类海外装运，为400磅[181.4千克]，对于第3类极端分销危险条件或军事应急目的，为300磅[136.0千克]。 1.2接线盒的性能取决于其制造的部件；因此，规定了反映不同性能的各种类型、类别、风格和处理。 本规范不包括在所有大气、搬运、运输和储存条件下的线装盒性能。符合危险品模式法规或美国联邦法规（CFR）的接线盒见补充要求。 1.3可接受并允许使用其他施工方法或技术，前提是由此产生的包装系统的性能与使用这些指定材料和程序产生的性能相同或更好。适当的实践D 4169分配周期可用于制定比较程序和标准。 1.4 单位 --以英寸-磅为单位的数值应视为标准值。括号中给出的SI值是数学值。每个系统中规定的值不是精确的等价物；因此，每个系统必须相互独立使用。将两个系统的值合并可能会导致不符合标准。有关单位转换，请参见IEEE/SI 10。 1.5 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全和健康实践，并确定监管限制的适用性。

1.1 This specification covers the fabrication of new wirebound general purpose (GP) panelboard (hereafter referred to as wirebound boxes) shipping boxes intended for use as containers for domestic and overseas shipment of general materials and supplies, not exceeding 500 lb [226.8 kg] for class 1 domestic, 400 lb [181.4 kg] for Class 2 overseas shipments or 300 lb [136.0 kg] for Class 3 extreme distribution hazard conditions or military contingency purposes. 1.2 Wirebound box performance is dependent on its fabricated components; therefore, a variety of types, classes, styles, and treatments reflecting varied performance are specified. This specification does not cover wirebound box performance under all atmosphere, handling, shipping, and storage conditions. Wirebound boxes in compliance with Hazardous Material Modal Regulations or United States Code of Federal Regulations (CFRs) are found in the Supplementary Requirements. 1.3 The use of other construction methods or techniques are acceptable and shall be permitted, provided the resulting packaging systems are of equal or better performance than would result from the use of these specified materials and procedures. The appropriate Practice D 4169 distribution cycle(s) can be used to develop comparative procedures and criteria. 1.4 Units --The values stated in inch-pound units are to be regarded as standard. The SI values given in brackets are mathematical. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. See IEEE/SI 10 for conversion of units. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.