1.1 本规范涵盖了片状和管状形式的预制柔性弹性体多孔隔热材料。1级涵盖工作温度为-183至104°C【-297至220°F】的商业或工业系统上使用的材料，2级涵盖工作温度为-183至150°C【-297至300°F】的工业系统上使用的材料，3级涵盖工作温度为-183至120°C【-297至250°F】的工业系统上使用的材料，其中允许最大200 ppm的可浸出氯化物和氟化物。 1.2 以SI单位或英寸-磅单位表示的值应单独视为标准值。每个系统中陈述的值可能不完全等同；因此，每个系统应独立使用。组合来自两个系统的值可能会导致非-符合标准。 1.3 本标准并不旨在解决与其使用相关的所有安全性问题（如果有）。本标准的使用者有责任在使用前建立适当的安全、健康和环境实践并确定法规限制的适用性。 1.4 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。

1.1 This specification covers preformed flexible elastomeric cellular-thermal insulation in sheet and tubular form. Grade 1 covers materials to be used on commercial or industrial systems with operating temperatures from –183 to 104°C [–297 to 220°F], Grade 2 covers material used on industrial systems with operating temperatures from –183 to 150°C [–297 to 300°F], and Grade 3 covers material used on industrial systems with operating temperatures from –183 to 120°C [–297 to 250°F] where a maximum of 200 ppm of leachable chlorides and fluorides are permitted. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.