1.1
This consumer safety specification establishes safety performance requirements, test methods, and labeling requirements to minimize the hazards to children presented by diaper changing tables as identified in the introduction.
1.2
This specification is intended to apply to diaper changing tables for commercial use. It is intended for use with children up to 3.5 years of age and weighing less than 50 lbs.
1.3
No diaper changing table produced after the approval date of this consumer safety performance specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements herein.
1.4
The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.5
The following precautionary caveat pertains only to the test method portion, Section
7
, of this consumer safety specification:
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6
This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.