首页 馆藏资源 舆情信息 标准服务 科研活动 关于我们
现行 ASTM D3655-22
到馆提醒
收藏跟踪
购买正版
Standard Performance Specification for Men's and Women's Sliver Knitted Overcoat and Jacket Fabrics 男子标准性能规范;s和女性;s细条针织外套和夹克面料
发布日期: 2022-11-01
1.1 本性能规范涵盖由任何纺织纤维或纺织纤维混合物组成的男女棉条针织大衣和夹克织物。 1.2 本性能规范不适用于衬布用针织面料。 1.3 这些要求适用于与织物方向相关的属性的长度和宽度方向。 1.4 本标准并不旨在解决与其使用相关的所有安全问题(如有)。本标准的使用者有责任在使用前建立适当的安全、健康和环境实践,并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒(TBT)委员会发布的《国际标准、指南和建议制定原则决定》中确立的国际公认标准化原则制定的。 =====意义和用途====== 4.1 买卖双方达成一致后,最终用途的机织物应满足 表1 本规范的要求。 (A) 可以使用多种方法来测量这些特性。这些方法不能互换使用,因为它们之间没有整体相关性(请参见 注2 , 注3 和 注释7 ). (B) 颜色变化的AATCC灰度。 (C) 染色用AATCC灰度。 (D) AATCC 9步色转移量表。 (E) 据报道,通过标准AATCC测试方法,对含有聚酯和氨纶或其混合物的深色染色织物的染色结果可能无法显示此类织物在消费者使用中的全部染色倾向。因此,建议这些试验获得的染色结果不用于此类织物的验收试验。 4.2 人们认识到,出于时尚或美学的目的,由这些织物制成的物品的最终消费者可能会发现可接受的织物不符合 表1 。因此 表1 可通过买卖双方的共同协议进行修改。 4.2.1 在这种情况下,对本规范的任何引用应规定:该织物符合ASTM规范 第3655页 除了以下特征之外。 4.3 如果买方和卖方之间未达成预购协议,如果存在争议 表1 仅供参考。如中所述 4.2 最终的消费者需求决定了任何特定风格织物的不同性能参数。 4.4 特定特性和测试方法的用途和意义在指定测试方法的适当章节中讨论。
1.1 This performance specification covers men's and women's sliver knitted overcoat and jacket fabrics composed of any textile fiber or mixture of textile fibers. 1.2 This performance specification is not applicable to knitted fabrics used for interlinings. 1.3 These requirements apply to the length and width directions for those properties where fabric direction is pertinent. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 4.1 Upon mutual agreement between the purchaser and the seller, woven fabrics intended for this end use should meet all of the requirements listed in Table 1 of this specification. (A) More than one method can be used to measure these properties. These methods cannot be used interchangeably since there can be no overall correlation between them (see Note 2 , Note 3 , and Note 7 ). (B) AATCC Gray Scale for Color Change. (C) AATCC Gray Scale for Staining. (D) AATCC 9-Step Chromatic Transference Scale. (E) It has been reported that the results for staining, obtained by standard AATCC Test Methods, on fabrics dyed to dark shades that contain a combination of polyester and spandex, or their blends, may not show the full staining propensity of such fabrics in consumer use. It is, therefore, recommended that the staining results obtained by these tests not be used for acceptance testing of such fabrics. 4.2 It is recognized that for purposes of fashion or aesthetics the ultimate consumer of articles made from these fabrics may find acceptable fabrics that do not conform to all of the requirements in Table 1 . Therefore, one or more of the requirements listed in Table 1 may be modified by mutual agreement between the purchaser and the seller. 4.2.1 In such cases, any references to the specification shall specify that: This fabric meets ASTM Specification D3655 except for the following characteristic(s). 4.3 Where no prepurchase agreement has been reached between the purchaser and the seller, and in case of controversy, the requirements listed in Table 1 are intended to be used as a guide only. As noted in 4.2 , ultimate consumer demands dictate varying performance parameters for any particular style of fabric. 4.4 The uses and significance of particular properties and test methods are discussed in the appropriate sections of the specified test methods.
分类信息
关联关系
研制信息
归口单位: D13.61
相似标准/计划/法规