1.1本试验方法包括评估工厂涂覆的厚度为0.025至0.05in的富锌底漆/铬酸盐复合涂层的成形性和附着力。（0.65至1.25 mm），典型用于卷材涂层行业。 1.2成型前的除油程度、胶带技术和胶带粘合强度的差异可能会影响粘合等级。 1.3以英寸-磅为单位的数值应视为标准值。括号中给出的值仅供参考。 1. 4本标准无意解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全和健康实践，并确定监管限制的适用性。有关具体的危险说明，请参阅第7节。

1.1 This test method covers the evaluation of the formability and adhesion of factory applied zinc-rich primer/ chromate complex coatings on steel with thicknesses of 0.025 to 0.05 in. (0.65 to 1.25 mm) typical of those used in the coil coating industry. 1.2 The degree of oil removal prior to forming, the techniques of taping, and differences in adhesive strength of the tape can affect the adhesion rating. 1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see Section 7.