1.1 本规范适用于设计用于带有6毫米软空气射弹的软空气运动参与者的眼睛保护装置（EPD）。这些EPD旨在最大限度地减少或显著减少因软空气射弹的冲击和穿透而对眼睛和附件造成的伤害。 1.2 当使用软气枪进行靶练习时，使用纸制或凝胶靶和足以防止弹跳的逆止器，射手可以佩戴适合与符合ANSI Z87.1的枪支、子弹（BB）枪或气枪一起使用的护目镜（射击眼镜）。本规范的平衡适用于为使用软空气枪的战术运动参与者设计的EPD。 1.3 符合本规范要求的EPD可保护眼睛和附件，而不一定保护头部的任何其他部位。 1.4 根据制造商提供的信息，本规范不限制与EPD一起使用时佩戴眼镜或隐形眼镜 9.2.21 . 1.5 单位- 以国际单位制表示的数值应视为标准。本标准不包括其他计量单位。 1.6 为实验室提供以下信息，以保护其人员: 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.7 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。

1.1 This specification applies to eye protective devices (EPDs) designed for use by participants in the sport of airsoft with 6-mm airsoft projectiles. These EPDs are designed to minimize or significantly reduce injury to the eye and adnexa as a result of impact and penetration of airsoft projectiles. 1.2 When airsoft guns are used for target practice with a paper or gel target and a backstop sufficient to prevent ricochet, shooters may wear eye protection (shooting glasses) appropriate for use with firearms, ball bullet (BB) guns or air guns that meet ANSI Z87.1. The balance of this specification applies to EPDs designed for use by participants in tactical sports using airsoft guns. 1.3 EPDs meeting the requirements of this specification offer protection to the eyes and adnexa and not necessarily to any other parts of the head. 1.4 This specification does not limit the wearing of eyeglasses or contact lenses when used in conjunction with the EPD based on the information provided by the manufacturer in 9.2.21 . 1.5 Units— The values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard. 1.6 The following information is provided for the laboratory conducting the test for the protection of their personnel: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.