BS EN 60034-27-3:2016提供了试验程序和试验结果解释指南 定子绕组绝缘介质损耗因数测量的试验结果 旋转电机。这些指南适用于带有 额定电压为6 kV及以上的导电槽涂层。本标准适用于铁芯（未安装）外的单个成型绕线定子线棒和线圈， 单个定子线棒和线圈安装在一个铁芯和完整的形式中- 绕线定子 新机器或旧机器的绕组。本国际标准适用于所有类型的真空浸渍或富含树脂（fullyloaded） 带条、线圈和完整绕组。不适用于未受孕的个体 棒和线圈或未浸渍的完整绕组。单绕组定子介质损耗因数特性的要求 额定电压为6 kV及以上的机器的棒和线圈，用 给出了50 Hz或60 Hz的交流电压。 交叉引用:IEC 60060-1IEC 60060-2EN 60060-1EN 60060-2EN 50209:1998IEEE 286:2000IEC TS 60034-27IEC TS 60034-27-2购买时可用的所有现行修订版均包含在本文件的购买中。

BS EN 60034-27-3:2016 provides guidelines for the test procedures and the interpretation of test results for dielectric dissipation factor measurements on the stator winding insulation of rotating electrical machines. These guidelines are valid for rotating electrical machines with conductive slot coatings operating at a rated voltage of 6 kV and higher.This standard applies to individual form-wound stator bars and coils outside a core (uninstalled), individual stator bars and coils installed in a core and complete form-wound stator winding of machines in new or aged condition.This International Standard applies to all kind of vacuum impregnated or resin-rich (fullyloaded) taped bars, coils and complete windings. It is not applicable to non-impregnated individual bars and coils or non-impregnated complete windings.Requirements for the dielectric dissipation factor characteristics of individual form-wound stator bars and coils of machines with rating voltages from 6 kV and higher when tested with 50 Hz or 60 Hz alternating voltages are given.Cross References:IEC 60060-1IEC 60060-2EN 60060-1EN 60060-2EN 50209:1998IEEE 286:2000IEC TS 60034-27IEC TS 60034-27-2All current amendments available at time of purchase are included with the purchase of this document.