1.1 本规程涵盖了铸造金属外科植入物和相关焊件的射线检测程序。 1.2 单位-- 以国际单位制或英寸-磅单位表示的值应单独视为标准值。每个系统中所述的值不一定是完全等效的；因此，为确保符合标准，每个系统应独立使用，两个系统的值不得组合。 1.3 本标准并不旨在解决与其使用相关的所有安全问题（如果有的话）。 本标准的使用者有责任在使用前建立适当的安全、健康和环境实践，并确定监管限制的适用性。 1.4 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。 =====意义和用途====== 4.1 本规程中的要求旨在控制铸造金属外科植入物和相关焊件的射线照相图像的质量。

1.1 This practice covers the procedure for radiographic testing of cast metallic surgical implants and related weldments. 1.2 Units— The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 4.1 The requirements in this practice are intended to control the quality of the radiographic image of cast metallic surgical implants and related weldments.