1.1 本规范涵盖了聚氯乙烯（PVC）污水管和排水管及配件的材料、尺寸、工艺、耐化学性和接头紧密性的要求和测试方法。多孔管也被覆盖；接头紧密性试验不适用于穿孔管。还包括表明符合本规范的标记形式。 1.2 本规范的文本参考了提供解释材料的注释、脚注和附录。这些注释和脚注（不包括表和图中的注释和脚注）不应视为本规范的要求。 1.3 以英寸-磅为单位的数值应视为标准值。括号中给出的值仅供参考。 1.4 以下预防性警告仅适用于试验方法部分第节 7. ，本规范: 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。

1.1 This specification covers requirements and test methods for materials, dimensions, workmanship, chemical resistance, and joint tightness of poly(vinyl chloride) (PVC) sewer and drain pipe and fittings. Perforated pipe is also covered; the joint tightness test is not applicable for perforated pipe. A form of marking to indicate compliance with this specification is also included. 1.2 The text of this specification references notes, footnotes, and appendixes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification. 1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 The following precautionary caveat pertains only to the test methods portion, Section 7 , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.