1.1 本试验方法涵盖了通过冲击EIF快速变形的程序，用于评估此类变形的影响。 1.2 以国际单位制或英寸-磅单位表示的数值应单独视为标准值。每个系统中规定的值不一定是精确的等价物；因此，为确保符合本标准，每个系统应独立使用，且两个系统的值不得组合。 1.3 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任制定适当的安全、健康和环境实践，并在使用前确定监管限制的适用性。 1.4 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。 ====意义和用途====== 5.1 本规范确定了PB和PI类EIF下的抗冲击性水平。 5.2 本试验方法无意模拟在使用中遇到的冲击。

1.1 This test method covers a procedure for rapidly deforming by impact an EIFS for evaluating the effect of such deformation. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and to determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 5.1 This specification determines levels of impact resistance under Classes PB and PI EIFS. 5.2 This test method does not purport to simulate impact encountered in service.