1.1 本说明书涵盖了通过长丝缠绕制造的用于地上垂直安装的圆柱形罐，以在大气压下容纳如本文所分类的侵蚀性化学品，并且由商业级聚酯或乙烯基酯树脂制成。包括对材料、性能、设计、结构、尺寸、公差、工艺和外观的要求。 1.2 本说明书不涵盖预期用于高于大气压或在真空条件下的压力的容器的设计，除非本文分类，或预期用于加热高于其闪点的液体的容器的设计。 1.3 以英寸-磅单位表示的值应被视为标准值。括号中给出的值是对SI单位的数学转换，仅供参考，不被视为标准。1.4 对于承受环境和/或机械力（如地震、风、冰、搅动或流体动力）的储罐，对于工作温度大于180°F（82°C）的储罐，以及底部无支撑的储罐，应给予特殊设计考虑。 1.5 以下安全危害警告仅适用于试验方法部分，章节 11 本说明书: 本标准并不旨在解决与其使用相关的所有安全性问题（如果有）。本标准的使用者有责任在使用前建立适当的安全、健康和环境实践并确定法规限制的适用性。 附注1: 没有已知的与该标准相当的ISO。 1.6 本国际标准是根据th发布的关于制定国际标准、指南和建议的原则的决定中确立的国际公认的标准化原则制定的e世界贸易组织技术性贸易壁垒委员会。

1.1 This specification covers cylindrical tanks fabricated by filament winding for above-ground vertical installation, to contain aggressive chemicals at atmospheric pressure as classified herein, and made of a commercial-grade polyester or vinylester resin. Included are requirements for materials, properties, design, construction, dimensions, tolerances, workmanship, and appearance. 1.2 This specification does not cover the design of vessels intended for pressure above atmospheric or under vacuum conditions, except as classified herein, or vessels intended for use with liquids heated above their flash points. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 Special design consideration shall be given to tanks subject to environmental and/or mechanical forces such as seismic, wind, ice, agitation, or fluid dynamic forces, to operational service temperatures greater than 180°F (82°C) and to tanks with unsupported bottoms. 1.5 The following safety hazards caveat pertains only to the test method portion, Section 11 , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Note 1: There is no known ISO equivalent to this standard. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.