IEC 61000中有关EMC发射要求的本部分适用于拟用于下述工业环境的电气和电子设备。 涵盖0 Hz至400 GHz频率范围内的发射要求。无需在未规定要求的频率下进行测量。 如果没有相关的专用产品或产品系列EMC排放标准，则本通用EMC排放标准适用。 本标准适用于拟连接至高压或中压变压器供电网络的设备，该变压器专用于为制造厂或类似工厂供电，并拟在工业场所内或附近运行，如下所述。 本标准也适用于由电池供电并拟用于工业场所的设备。 本标准所涵盖的环境包括室内和室外工业环境。 此外，工业场所还具有以下一个或多个示例: -工业、科学和医疗（ISM）仪器； -频繁切换的重感应或电容性负载； -高电流和相关磁场。 本标准的目的是定义与连续和瞬态、传导和辐射干扰相关的范围内定义的设备的发射试验要求。 选择排放要求是为了确保在工业场所正常运行的设备产生的干扰不超过可能阻止其他设备按预期运行的水平。未考虑设备的故障条件。在本标准中，并非所有干扰现象都包含在测试中，但仅包括与本标准所涵盖的设备相关的干扰现象。这些要求代表了基本的电磁兼容性发射要求。 对每个考虑的港口都规定了要求。

This part of IEC 61000 for EMC emission requirements applies to electrical and electronic apparatus intended for use in industrial environments as described below. Emission requirements in the frequency range 0 Hz to 400 GHz are covered. No measurement needs to be performed at frequencies where no requirement is specified. This generic EMC emission standard is applicable if no relevant dedicated product or product-family EMC emission standard exists. This standard applies to a apparatus intended to be connected to a power network supplied from a high or medium voltage transformer dedicated to the supply of an installation feeding manufacturing or similar plant, and intended to operate in or in proximity to industrial locations, as described below. This standard applies also to apparatus, which is battery operated and intended to be used in industrial locations. The environments encompassed by this standard are industrial, both indoor and outdoor. Industrial locations are in addition characterised by the existence of one or more of the following examples: - industrial, scientific and medical (ISM) apparatus; - heavy inductive or capacitive loads that are frequently switched; - high currents and associated magnetic fields. The object of this standard is to define the emission test requirements for apparatus defined in the scope in relation to continuous and transient, conducted and radiated disturbances. The emission requirements have been selected so as to ensure that disturbances generated by apparatus operating normally in industrial locations do not exceed a level that could prevent other apparatus from operating as intended. Fault conditions of apparatus are not taken into account. Not all disturbance phenomena have been included for testing purposes in this standard but only those considered as relevant for the equipment covered by this standard. These requirements represent essential electromagnetic compatibility emission requirements. Requirements are specified for each port considered.