本欧洲标准规定了对结构密封胶玻璃（SSG）应用中使用支撑和不支撑玻璃产品的适用性的要求。 SSG系统的四个示意图如图1所示，SSG II型系统的三个截面图如图2所示。本欧洲玻璃制品标准被认为是相关标准中规定的关于验证SSG系统适用性的要求的补充。 本欧洲标准仅考虑了钠钙硅酸盐玻璃。 塑料玻璃不在本欧洲标准的范围之内。 符合本欧洲标准要求的任何玻璃制品适用于ETAG 002）结构密封胶玻璃系统中定义的SSG系统。 在FprEN 13022-2:20131第5条所述的受控环境条件下，所有玻璃制品都安装并固定在支架中。 当绝缘玻璃单元的外部密封件具有结构功能和/或暴露于紫外线辐射而没有任何保护时，在该单元的构造中仅允许使用基于硅酮的密封剂

This European Standard specifies requirements for the suitability for use of supported and unsupported glass products for use in Structural Sealant Glazing (SSG) applications. Four schematic drawings of SSG systems are shown in Figure 1 and three section drawings of an SSG type II system are shown in Figure 2 for illustration purposes. This European Standard on glass products is considered as a supplement to the requirements specified in the corresponding standards with regard to verifying the suitability for use in SSG systems. Only soda lime silicate glasses are taken into consideration in this European Standard. Plastic glazing is excluded from the scope of this European Standard. Any glass products meeting the requirements of this European Standard are suitable for use in SSG systems as defined in ETAG 002 ) Structural sealant glazing system. All glass products are installed and bonded into the support under controlled environmental conditions as described in Clause 5 of FprEN 13022-2:20131. When the outer seal of the insulating glass unit has a structural function and/or is exposed to UV radiation without any protection, only silicone based sealant are permitted in the construction of the unit.