首页 馆藏资源 舆情信息 标准服务 科研活动 关于我们
现行 IEC 61280-2-1:2010
到馆阅读
收藏跟踪
购买正版
Fibre optic communication subsystem test procedures - Part 2-1: Digital systems - Receiver sensitivity and overload measurement 光纤通信子系统测试程序第2-1部分:数字系统 - 接收机灵敏度和过载测量
发布日期: 2010-03-18
IEC 61280-2-1:20 10(E)描述了适用于数字光纤通信和数据系统的测试程序。本测试程序的目的是测量光纤系统的光输入端口所需和允许的最小和最大光功率,以确保其在规定的限制内运行。另一个目的是验证在终端设备制造商规定的最小和最大光输入功率下获得有保证的差错性能。与上一版相比的主要变化是: -修订以包括与数据通信设备、再生器和放大器有关的要求; -术语“跨接导线”已被“测试线”取代; -增加了定义部分; -增加了有关测量不确定度的章节。
IEC 61280-2-1:2010(E) describes the test procedures applicable to digital fibre optic communication and data systems. The object of this test procedure is to measure the minimum and maximum optical powers required and allowed at the optical input port of a fibre optic system to ensure its operation within specified limits. Another objective is to verify that the guaranteed error performance is obtained at the minimum and the maximum optical input powers specified by the terminal equipment manufacturer. The main changes with respect to the previous edition are:
- revised to include the requirements associated with data communication equipment, regenerators and amplifiers;
- the term "jumper lead" has been replaced by "test cord";
- a section for definitions has been added;
- a section on measurement uncertainties has been added.
分类信息
关联关系
研制信息
归口单位: TC 86/SC 86C
相似标准/计划/法规
现行
IEC 61280-1-1-2013
Fibre optic communication subsystem basic test procedures - Part 1-1: Test procedures for general communication subsystems - Transmitter output optical power measurement for single-mode optical fibre cable
光纤通信子系统基本测试程序 - 第1-1部分:通用通信子系统的测试程序 - 单模光纤电缆的发射机输出光功率测量
2013-05-21
现行
BS 11/30247495 DC
BS EN 61280-1-1. Fibre optic communication subsystem basic test procedures. Part 1-1. Test procedures for general communication subsystems. Transmitter output optical power measurement for single-mode optical fibre cable
英国标准EN 61280-1-1 光纤通信子系统基本测试程序 第1-1部分 通用通信子系统的测试程序 单模光缆发射机输出光功率的测量
2011-05-16
现行
IEC 61280-1-4-2023 RLV
Fibre optic communication subsystem test procedures - Part 1-4: General communication subsystems - Light source encircled flux measurement method
光纤通信子系统试验程序.第1-4部分:一般通信子系统.光源环绕通量测量方法
2023-01-19
现行
KS C IEC 61280-1-4
광통신 부시스템의 시험 절차 — 제1-4부: 일반 통신 부시스템 — 광원 원형 광선속 측정방법
光纤通信子系统试验程序.第1-4部分:一般通信子系统.光源环绕通量测量方法
2022-11-21
现行
IEC 61280-1-4-2023
Fibre optic communication subsystem test procedures - Part 1-4: General communication subsystems - Light source encircled flux measurement method
光纤通信子系统试验程序.第1-4部分:一般通信子系统.光源环绕通量测量方法
2023-01-19
现行
KS C IEC 61280-1-4(2017 Confirm)
광통신 부시스템 시험 절차-제1-4부:일반 통신 부시스템-다중모드 광섬유 레이저 송신기에 적용되는 2차원 근접장 데이터의 검출과 감차변환
光纤通信子系统试验规程第1-4部分:通用通信子系统多模光纤激光发射机二维近场数据的采集和简化
2007-11-30
现行
IEC 61280-1-3-2021 RLV
Fibre optic communication subsystem test procedures - Part 1-3: General communication subsystems - Measurement of central wavelength, spectral width and additional spectral characteristics
光纤通信子系统试验程序第1-3部分:一般通信子系统中心波长、光谱宽度和附加光谱特性的测量
2021-07-05
现行
IEC 61280-1-3-2021
Fibre optic communication subsystem test procedures - Part 1-3: General communication subsystems - Measurement of central wavelength, spectral width and additional spectral characteristics
光纤通信子系统试验程序.第1-3部分:通用通信子系统.中心波长、光谱宽度和附加光谱特性的测量
2021-07-05
现行
BS 08/30180433 DC
BS EN 61280-2-1. Fibre optic communication subsystem basic test procedures. Part 2-1. Test procedures for digital systems. Receiver sensitivity and overload measurement
英国标准EN 61280-2-1 光纤通信子系统基本测试程序 第2-1部分 数字系统的测试程序 接收机灵敏度和过载测量
2008-03-31
现行
IEC 61280-2-2-2012
Fibre optic communication subsystem test procedures - Part 2-2: Digital systems - Optical eye pattern, waveform and extinction ratio measurement
光纤通信子系统测试程序 - 第2-2部分:数字系统 - 光学眼图 波形和消光比测量
2012-10-25
现行
KS C IEC 61280-2-2
광통신 부시스템의 시험 절차 — 제2-2부: 디지털 시스템 — 광 아이패턴형, 파형 및 소광비의 측정
光纤通信子系统试验程序.第2-2部分:数字系统.光学眼图、波形和消光比测量
2022-11-21
现行
IEC 61280-2-13-2024
Fibre optic communication subsystem test procedures - Part 2-13: Digital systems - Measurement of error vector magnitude
光纤通信子系统试验程序.第2-13部分:数字系统.误差矢量幅值的测量
2024-07-17
现行
IEC 61280-4-1-2019+AMD1-2021 CSV
Fibre-optic communication subsystem test procedures - Part 4-1: Installed cabling plant - Multimode attenuation measurement
光纤通信子系统试验程序第4-1部分:已安装的布线设备多模衰减测量
2021-12-09
现行
IEC 61280-4-1-2019
Fibre-optic communication subsystem test procedures - Part 4-1: Installed cabling plant - Multimode attenuation measurement
光纤通信子系统试验程序第4-1部分:已安装的布线设备多模衰减测量
2019-05-22
现行
IEC 61280-4-1-2019/AMD1-2021
Amendment 1 - Fibre-optic communication subsystem test procedures - Part 4-1: Installed cabling plant - Multimode attenuation measurement
修改件1.光纤通信子系统试验程序.第4-1部分:已安装的布线设备.多模衰减测量
2021-12-09
现行
IEC 61280-2-3-2009
Fibre optic communication subsystem tets procedures - Part 2-3: Digital systems - Jitter and wander measurements
光纤通信子系统tets程序.第2-3部分:数字系统.抖动和漂移测量
2009-07-14
现行
IEC 61280-4-2-2024 RLV
Fibre-optic communication subsystem test procedures - Part 4-2: Installed cabling plant - Single-mode attenuation and optical return loss measurements
光纤通信子系统试验程序.第4-2部分:已安装的布线设备.单模衰减和光回波损耗测量
2024-05-06
现行
IEC 61280-4-2-2024
Fibre-optic communication subsystem test procedures - Part 4-2: Installed cabling plant - Single-mode attenuation and optical return loss measurements
光纤通信子系统试验程序.第4-2部分:已安装的布线设备.单模衰减和光回波损耗测量
2024-05-06
现行
DIN IEC 61280-1-3-DRAFT
Draft Document - Fibre optic communication subsystem basic test procedures - Part 1-3: Test procedures for general communication subsystems - Central wavelength and spectral width measurement (IEC 86C/838/CD:2008)
文件草稿.文件草稿.光纤通信子系统基本试验程序.第1-3部分:一般通信子系统的试验程序.中心波长和光谱宽度测量(IEC 86C/838/CD:2008)
2008-07-01
现行
BS 07/30174261 DC
BS EN 61280-2-3. Fibre optic communication subsystem basic test procedures. Part 2-5. Test procedures for digital systems. Jitter and wander measurements
英国标准EN 61280-2-3 光纤通信子系统基本测试程序 第2-5部分 数字系统的测试程序 抖动和漂移测量
2007-11-23