1.1 本试验方法包括使用盘式疲劳试验机测定橡胶中的轮胎帘线因压缩或拉伸或两者兼有而产生的疲劳。疲劳被测量为强度损失。 1.2 以国际单位制或英寸-磅单位表示的数值应单独视为标准值。每个系统中规定的值可能不是精确的等效值；因此，每个系统应相互独立使用。将两个系统的值合并可能会导致不符合标准。 1.3 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全和健康实践，以确定监管限制的适用性。 ====意义和用途====== 5.1 在缺乏实验室间精度的可靠信息的情况下，不建议将本试验方法用于商业装运的验收试验。 5.1.1 如果两个实验室（或更多实验室）报告的测试结果之间存在实际意义上的差异，则应进行比较测试，以确定它们之间是否存在统计偏差，并使用主管的统计协助。至少，应使用尽可能均匀的测试样品，从获得不同测试结果的材料中提取，并以相同数量随机分配给每个实验室进行测试。 具有既定测试值的其他织物可用于此目的。应使用未配对数据的统计测试，在测试系列之前选择的概率水平上，比较两个实验室的测试结果。如果发现偏差，必须找到并纠正其原因，或者考虑到已知偏差，调整未来的测试结果。

1.1 This test method covers the determination of fatigue of tire cords in rubber due to compression or extension, or both, using a disc fatigue tester. The fatigue is measured as a loss in strength. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices to determine the applicability of regulatory limitations prior to use. ====== Significance And Use ====== 5.1 This test method is not recommended for acceptance testing of commercial shipments in the absence of reliable information on between-laboratory precision. 5.1.1 If there are differences of practical significance between the reported test results for two laboratories (or more), a comparative test should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, test samples should be used that are as homogeneous as possible, that are drawn from a material from which the disparate test results were obtained, and that are randomly assigned in equal numbers to each laboratory for testing. Other fabrics with established test values may be used for this purpose. The test results from the two laboratories should be compared using a statistical test for unpaired data, at a probability level chosen prior to the testing series. If a bias is found, either its cause must be found and corrected, or future test results must be adjusted in consideration of the known bias.