本文件规定了一系列测定压敏电阻能力的方法 胶带在与胶带和基材表面平行的恒定载荷下保持粘合。 本文件包括:-方法A:自粘胶带-垂直标准钢板剪切附着力的测量；-方法B:自粘胶带-对覆盖有粘合剂的垂直面板剪切附着力的测量 NIST SRM 1810A1）标准纤维板方法C:自粘胶带-对覆盖有胶带的垂直面板剪切附着力的测量 买方和卖方约定的纤维板方法D:自粘胶带.应用的纤维增强胶带剪切附着力的测量 安装在水平标准钢板上；-方法E:自粘胶带.应用的纤维增强胶带剪切附着力的测量 至覆盖NIST SRM 1810A1）标准纤维板的水平面板方法F:自粘胶带.纤维增强胶带剪切附着力的测量 安装在由买方和卖方商定的纤维板覆盖的水平面板上； -方法G:自粘胶带-在高温下停留10分钟后测量垂直标准钢板的剪切附着力。交叉引用:EN 12481EN 1943:2002EN 10088-2包含以下内容:勘误表，2019年6月

This document specifies a series of methods for the determination of the ability of a pressure sensitive tape to remain adhered under a constant load applied parallel to the surfaces of the tape and substrate. This document contains:— method A: Self adhesive tapes - Measurement of shear adhesion to a vertical standard steel panel;— method B: Self adhesive tapes - Measurement of shear adhesion to a vertical panel covered with NIST SRM 1810A1) standard fibreboard;— method C: Self adhesive tapes - Measurement of shear adhesion to a vertical panel covered with a fibreboard agreed upon by the buyer and seller;— method D: Self adhesive tapes - Measurement of shear adhesion of filament reinforced tape applied to a horizontal standard steel panel;— method E: Self adhesive tapes - Measurement of shear adhesion of filament reinforced tape applied to a horizontal panel covered with NIST SRM 1810A1) standard fibreboard;— method F: Self adhesive tapes - Measurement of shear adhesion of filament reinforced tape applied to a horizontal panel covered with a fibreboard agreed upon by the buyer and seller;— method G: Self adhesive tapes - Measurement of shear adhesion to a vertical standard steel panel at elevated temperature after a 10 min dwell time.Cross References:EN 12481EN 1943:2002EN 10088-2Incorporates the following:Corrigendum, June 2019