1.1 本试验方法包括测定油漆和油漆配方中使用的碳氢化合物溶剂的相对溶剂能力。本试验方法适用于初始沸点超过40的溶剂 °C和低于300的干点 °C，当根据中的程序确定时 注1 . 注1: 试验方法 D86 用于测定矿物油和类似石油溶剂的初始沸点和干点。试验方法 D1078号 用于纯化合物和窄沸腾范围切割。 1.2 为了使用本试验方法确定观察值或计算值是否符合相关规范，应根据实践修约方法，将用于表示规范极限的最后一个右手数字中的试验结果修约为“最接近的单位” E29年 . 1.3 有关具体的危险信息和指导，请参阅供应商的材料安全数据表。 1.4 以国际单位制表示的数值应视为标准值。 本标准不包括其他计量单位。 1.5 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.6 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。 ====意义和用途====== 4.1 kauri丁醇值用于衡量碳氢化合物溶剂的溶剂能力。高kauri丁醇值表明相对较强的偿付能力。

1.1 This test method covers the determination of the relative solvent power of hydrocarbon solvents used in paint and lacquer formulations. This test method is suitable for use with solvents having an initial boiling point over 40 °C and a dry point under 300 °C when determined in accordance with the procedures in Note 1 . Note 1: Test Method D86 is used to determine the initial boiling point and dry point for mineral spirits and similar petroleum solvents. Test Method D1078 is used for pure compounds and narrow boiling range cuts. 1.2 For purposes of determining conformance of an observed or a calculated value using this test method to relevant specifications, test result(s) shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29 . 1.3 For specific hazard information and guidance, consult the supplier's Material Safety Data Sheet. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 4.1 The kauri-butanol value is used as a measure of solvent power of hydrocarbon solvents. High kauri-butanol values indicate relatively strong solvency.