1.1 本规范规定了钢板、薄板、带材和轧制棒材的要求。包括以下合金: 2. 先前 标称成分，% 铜合金 习惯于 UNS编号。 任命 铍 钴 镍 铁 C17500 合金10 0.6 2.5 . . C17510 合金3或14 0.4 . 1.8 . C71700 . 0.5 . 31 0.70 1.2 单位- 以英寸-磅为单位的数值应视为标准值。括号中给出的值是到国际单位制的数学转换，仅供参考，不被视为标准值。 1.3 以下安全危险警告仅适用于本规范中所述的试验方法: 1.4 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。

1.1 This specification establishes the requirements for plate, sheet, strip, and rolled bar. The following alloys are included: 2 Previously Nominal Composition, % Copper Alloy Used UNS No. Designation Beryllium Cobalt Nickel Iron C17500 Alloy 10 0.6 2.5 . . C17510 Alloy 3 or 14 0.4 . 1.8 . C71700 . 0.5 . 31.0 0.70 1.2 Units— The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 The following safety hazard caveat pertains only to the test methods described in this specification: 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.