1.1 本规范 2. 覆盖镍铬铁钼铜合金棒（UNS N06007、N06975、N06985、N06030、N08031和N08034） 3. 如中所示 表1- 3. ，用于一般腐蚀性环境。 1.2 本规范涵盖以下产品: 1.2.1 杆 5. / 16 英寸至 3. / 4. 英寸（7.94 mm至19.05 mm），不包括直径，热处理或冷处理，固溶退火和酸洗或机械除垢。 1.2.2 杆 3. / 4. 英寸至3英寸 1. / 2. 英寸（19.05 mm至88.9 mm），包括直径、热加工或冷加工、固溶退火、研磨或车削。 1.3 以英寸磅为单位的数值应视为标准。括号中给出的值是国际单位制的数学转换，仅供参考，不被视为标准。 1.4 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的使用者有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。

1.1 This specification 2 covers rod of Ni-Cr-Fe-Mo-Cu alloys (UNS N06007, N06975, N06985, N06030, N08031, and N08034) 3 as shown in Tables 1- 3 , for use in general corrosive service. 1.2 The following products are covered under this specification: 1.2.1 Rods 5 / 16 in. to 3 / 4 in. (7.94 mm to 19.05 mm) excl in diameter, hot- or cold-finished, solution annealed and pickled or mechanically descaled. 1.2.2 Rods 3 / 4 in. to 3 1 / 2 in. (19.05 mm to 88.9 mm) incl in diameter, hot- or cold-finished, solution annealed, ground or turned. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.