1.1 本规范涵盖了混凝土路面中使用的带保护性熔结环氧涂层的普通钢传力杆。 1.2 本规范适用于英磅单位（如规范A1078）或国际单位（如规格A1078M）的订单。 1.3 以英寸磅或国际单位表示的数值应单独视为标准值。在文本中，SI单位显示在括号中。每个系统中规定的值可能不完全相等；因此，每个系统应独立使用。组合两个系统的值可能导致不符合本规范。 1.4 本标准并不旨在解决与其使用相关的所有安全问题（如有）。本标准的使用者有责任在使用前建立适当的安全、健康和环境实践，并确定监管限制的适用性。 注1: 涂层涂敷器在本规范中被认定为制造商。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。

1.1 This specification covers plain steel dowel bars with protective fusion-bonded epoxy coating for use in concrete pavements. 1.2 This specification is applicable for orders in either inch-pound units (as Specification A1078) or in SI units (as Specification A1078M). 1.3 The values stated in either inch-pound or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with this specification. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Note 1: The coating applicator is identified throughout this specification as the manufacturer. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.