1.1 本试验方法包括通过滚动球测量压敏粘合剂的相对粘性，最适用于低粘性粘合剂。本试验方法仅为可用于测量粘性的几种方法之一。 1.1.1 本试验方法不推荐用于最终用途产品的规范。 1.2 以国际单位制或英寸-磅单位表示的数值应单独视为标准值。每个系统中规定的值可能不是精确的等效值，因此，每个系统必须独立使用，不得以任何方式组合值。 1.3 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全和健康实践，并确定监管限制的适用性。 1.4 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。 ====意义和用途====== 5.1 滚动球粘性测试快速、易于运行，并且需要很少的设备投资和很少的操作员培训。本试验主要用于质量控制，因为它在一个实验室内具有良好的再现性，并且能够在粘合剂膜厚度保持不变的情况下准确检测批次间的变化。滚球粘性不是一种研究工具，因为对于大多数压敏粘合剂应用，滚球粘性结果与应用粘性要求没有很好的相关性。

1.1 This test method covers measurement of the comparative tack of pressure-sensitive adhesives by a rolling ball and is most appropriate for low-tack adhesives. This test method is only one of several available for the measurement of tack. 1.1.1 This test method is not recommended for the specification of end use products. 1.2 Values stated in either SI or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents, therefore, each system must be used independently without combining values in any way. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 5.1 The rolling-ball tack test is fast, easy to run, and requires little investment in equipment and little operator training. This test is intended primarily for quality control use since it demonstrates good reproducibility within a single laboratory and ability to detect batch-to-batch variations accurately if adhesive film thickness is held constant. Rolling ball tack is not intended as an investigative tool since for most pressure sensitive adhesive applications rolling ball tack results do not correlate well with application tack requirements.