本欧洲标准规定了符合EN 1359，EN 12261，EN 12480，EN 12405和EN 14236的最大容量为40 m3/h，最大工作压力不超过500 mbar的燃气表的附加要求和试验，具有电池供电设备，提供形成燃气表（以下称为仪表）的一部分或包含在附加功能设备（AFD）中的附加功能。它还涵盖了使用电子索引而不是机械索引时的附加要求。如果规定了仪表一体式阀门的选项，本标准仅对最大容量不超过10 m3/h的仪表提出要求。 本欧洲标准适用于符合EN 437标准的第一，第二和第三种家庭气体。 本欧洲标准规定了电子元件的施工要求，但是通信协议在其他欧洲标准（例如， EN 13757的适当部分。 注意本欧洲标准涵盖与辅助设备的连接，但不包括对这些设备的要求。 本欧洲标准适用于安装在振动和冲击低的地方的AFD，并且: - 封闭位置（室内或室外保护作为

This European Standard specifies the additional requirements and tests for gas meters with a maximum capacity of 40 m3/h and a maximum operating pressure of not exceeding 500 mbar, conforming to EN 1359, EN 12261, EN 12480, EN 12405 and EN 14236, which have battery powered devices providing additional functionalities that form part of the gas meter (hereafter referred to as meter) or contained in an Additional Functionality Device (AFD). It also covers the additional requirements when an electronic index is used rather that a mechanical one. Where the option of an integral valve to the meter is specified, this standard only gives requirements for meters having a maximum capacity not exceeding 10 m3/h. This European Standard is applicable to first, second and third family gases according to EN 437. This European Standard specifies the construction requirements for electronic components but communication protocols are dealt within other European Standards, e.g. appropriate parts of EN 13757. NOTE This European Standard covers connections to auxiliary devices but not the requirements for these devices. This European Standard applies to AFDs that are installed in locations with vibration and shocks of low significance and in: - closed locations (indoor or outdoor with protection as specified by the manufacturer) with condensing or with non-condensing humidity, or, if specified by the manufacturer: - open locations (outdoor without any covering) with condensing humidity or with non-condensing humidity, - locations liable to temporary saturation, and in locations with electromagnetic disturbances corresponding to those likely to be found in residential, commercial buildings or similar buildings. This European Standard does not cover the changing of metrological software within the meter or the upload/download of metrological software. This European Standard only covers valves integral to the meter.