1.1 本试验方法涵盖了使用拉伸试验机测定固定在钉和叉紧固件上的按钮的保持强度。 1.2 本试验方法适用于服装上的纽扣或拟用于服装的织物上的纽扣（见 附件A1 ). 1.3 单位- 以国际单位制或英寸-磅单位表示的数值应单独视为标准值。每个系统中规定的值不一定是精确的等价物；因此，为确保符合本标准，每个系统应独立使用，且两个系统的值不得组合。 1.4 本标准并非旨在解决与其使用相关的所有安全问题（如有）。 本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。 ====意义和用途====== 5.1 本试验方法可用于带有扣子的服装的商业装运验收试验。 5.2 本试验方法可用于确定钉扣或叉扣扣与服装面料的兼容性。在这种情况下，纽扣将以其使用和测试组合单元的方式连接到织物上。

1.1 This test method covers the determination of the holding strength of a tack and prong fastener attached button using a tensile testing machine. 1.2 This test method is applicable to attached buttons in garments or to be attached to fabrics intended for use in apparel (see Annex A1 ). 1.3 Units— The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 5.1 This test method may be used for acceptance testing of commercial shipments of garments with attached buttons. 5.2 This test method may be used to determine the compatibility of tack attached buttons or prong fastener attached buttons to fabrics used in apparel. In which case, the buttons are attached to the fabric in the manner in which they will be used and the combined units tested.