本文档描述了手动固定的推杆、夹子和类似固定装置的装配力指南。在本文件中，“夹子”一词用于指代本文件中提到的所有保留装置。适用的固定装置必须使用手指/拇指直接对夹子施加力，并独立于其他紧固件手动固定。对于手动安装并独立于其他固定装置固定的固定装置，其必须完全固定，且不与相邻紧固件（即，硬装饰板背面的多个PIA夹）发生任何相互作用。本标准适用于与力插入方向成90度（10度）和/或垂直的接触面。本文件不包括机械安装的紧固件（螺钉、铆钉等）。本标准不适用于提取/保留力。 参考USCAR-44，了解与线束相连的夹子的其他指南。在创建本指南时，无法预期所有可能的设计和应用。自始至终都包含图片和示例以提供帮助。如果存在遵守指南的问题，请咨询负责的人体工程学部门或代表。

This document describes the assembly force guidelines for manually seated push-pins, clips, and similar retention devices. For the purpose of this document, the term ¿¿¿clip¿¿¿ is used to reference all retention devices addressed within this document. Applicable retention devices must have force exerted directly to the clip using the finger/thumb and are hand seated independent of other fasteners. For a retention device to be manually installed and seated independent of other retention devices, it must be seated fully without any interaction with an adjacent fastener (i.e., multiple PIA clips on the back of a hard trim panel).This standard applies to contact surfaces angled at 90 degrees (¿¿10 degrees) and/or perpendicular from the direction of force insertion. Mechanically installed fasteners (screws, rivets, etc.) are not included in this document. This standard does not apply to extraction/retention forces. Refer to USCAR-44 for additional guidelines for clips attached to wire harnesses.All possible design and applications could not be anticipated in creating this guideline. Pictures and examples are included throughout to assist. Where there are questions of adherence to the guideline, consult the responsible ergonomic departments or representatives.