1.1 本规范涵盖通过静电喷涂、植绒或流化床工艺涂覆保护性熔结环氧涂层的结构钢H型桩和板桩。 注1: 在本规范中，涂层涂敷器被认定为制造商。 1.2 涂层要求包含在 附件A1 . 1.3 本规范适用于英制磅单位（如A950规范）或国际单位制（如A950M规范）的订单。以英寸磅或国际单位制表示的数值应单独视为标准。在正文中，国际单位制显示在括号中。 1.4 本标准并不旨在解决与其使用相关的所有安全问题（如有）。 本标准的使用者有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。

1.1 This specification covers structural steel H-piles and sheet piling with protective fusion-bonded epoxy coating applied by the electrostatic spray, flocking, or fluidized bed process. Note 1: The coating applicator is identified throughout this specification as the manufacturer. 1.2 Requirements for coatings are contained in Annex A1 . 1.3 This specification is applicable for orders in either inch-pound units (as Specification A950) or SI units (as Specification A950M). The values stated in either inch-pound or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.