1.1 本规范涵盖钉子、钉子、订书钉和其他从动紧固件，如中所列 表1 . 注1: 紧固件延性信息见 表2 尺寸信息见表3-63。 1.2 本规范中所述的紧固件由手动工具、电动工具或机械装置以单次或多次撞击方式驱动，并由手动、工具或机器定位。 1.3 本规范适用于英寸磅（F1667）或国际单位制[F1667M]。SI中的值是两个有效数字的数学转换，并显示在括号中[ ]. 1.4 本规范中的紧固件以散装（散装）形式出售，并进行整理以装入应用工具的库中。除第节所述之外 9 、工艺、粘结材料（包括但不限于塑料、粘合剂、纸带、塑料条、塑料载体、金属丝等）和校对紧固件的相对方向不在本标准范围内。 1.5 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.6 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。

1.1 This specification covers nails, spikes, staples, and other driven fasteners, as listed in Table 1 . Note 1: Fastener ductility information is presented in Table 2 and dimensional information in Tables 3–63. 1.2 Fasteners described in this specification are driven by hand tool, power tool, or mechanical device in single or multiple strikes and are positioned by hand, tool, or machine. 1.3 This specification is applicable in either inch-pounds (F1667) or SI units [F1667M]. Values stated in SI are a mathematical conversion to two significant digits and are shown in brackets [ ]. 1.4 Fasteners in this specification are sold in bulk (loose) form and are collated for loading into the magazine of an application tool. Other than as covered in Section 9 , Workmanship, cohering materials (including, but not limited to, plastic, adhesive bond, paper tape, plastic strip, plastic carrier, wire, etc.) and relative orientation of collated fasteners are not within the scope of this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.