1.1 本指南为现场安全工程师提供了帮助，以选择设计特定场地、焊丝物理安全周界屏障所需的适当组件。 1.2 本标准并不旨在解决与其使用相关的所有物理保护安全问题（如有）。标准使用者有责任确定所需物理保护的适当设计水平，并确定监管要求或限制的适用性。 1.3 规格 F2453 将与本指南一起使用。 1.4 以英寸磅为单位的数值应视为标准。括号中给出的值是国际单位制的数学转换，仅供参考，不被视为标准。 1.5 本标准并不旨在解决与其使用相关的所有安全问题（如有）。本标准的使用者有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。第7节“危险”中给出了一些具体的危险说明。 1.6 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。

1.1 This guide provides assistance for the site security engineer to select the proper components required to design a site-specific, welded-wire physical security perimeter barrier. 1.2 This standard does not purport to address all of the physical protection security concerns, if any, associated with its use. It is the responsibility of the user of the standard to establish the appropriate design level of physical protection required and determine the applicability of regulatory requirements or limitations. 1.3 Specification F2453 is to be used in conjunction with this guide. 1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Some specific hazards statements are given in Section 7 on Hazards. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.