BS PD CEN/CLC/TR 16832:2015规定了选择、使用、护理和维护个人防护设备衣物和相关物品的指南，旨在防止危险区域的静电危害。静电不应与市电或其他形式的电流混淆；静电防护要求与电流相关危险防护要求不同。静电风险防护不应与电弧防护混淆；前者与电性能有关，后者与热、火焰和弹丸保护有关。指令89/686/EEC要求，用于爆炸性环境的PPE的设计和制造必须确保其不会产生电、静电或冲击- 可能导致爆炸性混合物点燃的感应电弧或火花。然而，本报告并未涉及静电点火的其他技术风险。然而，当认证PPE符合指令89/686/EEC的要求时，需要考虑其他可能的火源。注意EN 13463？1给出了评估可能用于某些PPE项目的非电气设备中可能的点火源的指南。交叉引用:EN 1081EN 1149-1EN 1149-2EN 1149-3EN 1149-5CEN/TR 15321:2006EN 16350EN 60079-10-1EN 60079-10-1EN 60079-10-2IEC 60079-10-2CLC/TR 60079-32-1:2015IEC/TS 60079-32-1:2013EN 60079-32-2:2015IEC 60079-32-2:2015EN 61340-4-1IEC 61340-4-1IEC 61340-4-3TR 61340-4-3EN 61340-4-ISO 11611364-ISO 1161884 ISO 116ISO ISO ISO ISO 1161884 ISO 116EN ISO 18644904 ISO ISO 116190420345ISO 20345EN ISO 20346ISO 20346EN ISO 20347ISO 20347ISO 7000ISO 1096584/47/EEC89/686/EEC2014/34/EU94/9/EC1999/92/ECASTM E582ASTM E2019CEN/TR 14560EN ISO 11612ISO 11612EN 13463- 1EN 13821EN 50286EN 60895IEC 60895EN 60984IEC 60984IEC 61482-2IEC 61241-2-3ISO/TR 15916IEC 60079-0EN 1149-2IEC 60050包含以下内容:勘误表，2017年3月

BS PD CEN/CLC/TR 16832:2015 sets out guidance for the selection, use, care and maintenance of clothing and related items of personal protective equipment designed to prevent hazards caused by static electricity in hazardous areas.Static electricity should not be confused with mains supply electricity, or other forms of electric current; the requirements for protection against static electricity are different to the requirements for protection against hazards associated with electric current. Protection against electrostatic risks should not be confused with protection against electric arc; the former is concerned with electrical properties and the latter is concerned with heat, flame and projectile protection.Directive 89/686/EEC requires that PPE intended for use in explosive atmospheres must be so designed and manufactured that it cannot be the source of an electric, electrostatic or impact-induced arc or spark likely to cause an explosive mixture to ignite. Whereas this Technical Report addresses electrostatic ignition risks, it does not address other possible sources of ignition. Nevertheless, other possible sources of ignition are required to be considered when certifying PPE to the requirements of Directive 89/686/EEC.NOTE EN 13463?1 gives guidance on assessing possible ignition sources in non-electrical equipment that may be used for some items of PPE.Cross References:EN 1081EN 1149-1EN 1149-2EN 1149-3EN 1149-5CEN/TR 15321:2006EN 16350EN 60079-10-1IEC 60079-10-1EN 60079-10-2IEC 60079-10-2CLC/TR 60079-32-1:2015IEC/TS 60079-32-1:2013EN 60079-32-2:2015IEC 60079-32-2:2015EN 61340-4-1IEC 61340-4-1EN 61340-4-3IEC 61340-4-3EN 61340-4-5IEC 61340-4-5EN ISO 11611ISO 11611EN ISO 13688ISO 13688CEN ISO/TR 18690ISO/TR 18690EN ISO 20344ISO 20344EN ISO 20345ISO 20345EN ISO 20346ISO 20346EN ISO 20347ISO 20347ISO 7000ISO 1096584/47/EEC89/686/EEC2014/34/EU94/9/EC1999/92/ECASTM E582ASTM E2019CEN/TR 14560EN ISO 11612ISO 11612EN 13463-1EN 13821EN 50286EN 60895IEC 60895EN 60984IEC 60984IEC 61482-2IEC 61241-2-3ISO/TR 15916IEC 60079-0EN 1149-2IEC 60050Incorporates the following:Corrigendum, March 2017