1.1 本规范涵盖了一组通用要求，除非适用的产品规范中另有规定，否则这些要求适用于桥式电缆线的线材。 1.2 本规范适用于标称直径11.0 mm的线材[ 7. / 16 英寸]至16.0毫米[ 5. / 8. in.]，用于桥接电缆线。 1.3 以英寸磅单位或国际单位制表示的数值应单独视为标准。每个系统中规定的值可能不是完全相等的；因此，每个系统应独立使用。 将两个系统的值合并可能导致不符合本规范。 1.4 本标准并不旨在解决与其使用相关的所有安全问题（如有）。本标准的使用者有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认的标准化原则制定的。

1.1 This specification covers a group of common requirements that, unless otherwise specified in the applicable product specification, apply to wire rod for bridge cable wire. 1.2 This specification is applied to wire rod with a nominal diameter of 11.0 mm [ 7 / 16 in.] to 16.0 mm [ 5 / 8 in.] intended for use in bridge cable wire. 1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with this specification. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.