1.1 这些测试方法包括测试用于生产薄膜绝缘磁线的液体搪瓷涂层。 1.2 以国际单位制或英寸-磅单位表示的数值应单独视为标准值。每个系统中规定的值不一定是精确的等价物；因此，为确保符合本标准，每个系统应独立使用，且两个系统的值不得组合 1.3 试验方法如下: 小节 密集 6 – 10 测定的固体 16 – 22 有效固体 31 – 37 闪点 11 – 15 红外分析 45 – 50 烟囱损耗 23 – 30 粘度 38 – 44 1.4 没有已知的IEC等效文件。 1.5 本标准并非旨在解决与其使用相关的所有安全问题（如有）。本标准的用户有责任在使用前制定适当的安全、健康和环境实践，并确定监管限制的适用性。 1.6 本国际标准是根据世界贸易组织技术性贸易壁垒（TBT）委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。 ====意义和用途====== 4.1 这些测试对于磁铁的制造、购买和使用过程中的规范和控制目的非常有用- 漆包线，并用于测定批次的均匀性。

1.1 These test methods cover testing liquid enamel coatings used to produce film-insulated magnet wire. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined 1.3 The test methods appear as follows: Sections Density 6 – 10 Determined Solids 16 – 22 Effective Solids 31 – 37 Flash Point 11 – 15 Infrared Analysis 45 – 50 Stack Loss 23 – 30 Viscosity 38 – 44 1.4 There is no known IEC equivalent document. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. ====== Significance And Use ====== 4.1 These tests are useful for specification and control purposes during the manufacture, purchase, and use of the magnet-wire enamels, and for determining uniformity of batches.