本文件规定了紫外线激光打印护套、镀银铜导体、， 电气设备用交联乙烯-四氟乙烯共聚物（XLETFE）系列电缆 在-65°C至150°C的温度下运行的飞机的机载电气系统，在海平面上的电压不超过600 V rms。该绝缘系统已在航空航天应用中使用，使用115 V（相对中性）400 Hz ac和28 Vdc。用户应负责验证电缆是否适用于其他电气系统。 当有护套时，这些电缆适合机身使用，无需额外保护。什么时候 护套被剥离，芯线可能需要额外保护。如果两者之间存在冲突 标准和其他参考文件应以本标准的要求为准。交叉引用:EN 2084EN 4611-005EN 2235EN 3475- 100EN 9133EN 2083EN 4612-002购买本文件时可获得的所有现行修订均包含在购买本文件中。

This document specifies the characteristics of UV laser printable jacket, silver plated copper conductor, electrical cables Crosslinked Ethylene Tetra Fluoro Ethylene co-polymer (XLETFE) family for use in the on-board electrical systems of aircraft operating at temperatures between – 65 °C and 150 °C, operating at voltages not exceeding 600 V rms at sea level. This insulation system has been used in aerospace applications using 115 V (phase-to-neutral) 400 Hz ac and 28 Vdc. Verification of the suitability of cables for use in other electrical systems is the responsibility of the user. These cables are suitable for airframe use without additional protection when the jacket is present. When the jacket is stripped back the cores may need additional protection. In case of conflict between this standard and other referenced documents the requirements of this standard shall take precedence.Cross References:EN 2084EN 4611-005EN 2235EN 3475-100EN 9133EN 2083EN 4612-002All current amendments available at time of purchase are included with the purchase of this document.